why earthing is not required on transformer prymary winding
side ???
- 13 Answers
- 23612 Views
- Genpact, I also Faced
- E-Mail Answers
Answer Posted / ravi
mr prashanth if u dont know the answer u not suppose to
blame any of the answers.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is servo motor? what is its purpose?
How the frame size of a flange mounted AC induction motor is calculated?
how we will deside the high voltage value
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
how calculate the electrical load for industry and office
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
what is is the potential diffrence between two phase ?
Explain the advantages and disadvantages of thermal power plant?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
why we use circuit breakers for switching instead of normal switching device?
