Which layer is responsible for routing through an internetwork? A.) Physical B.) Session C.) Network D.) Transport E.) Application F.) Data Link

The maximum distance on a 10BaseT network from the hub to a workstation is which of the following? A.) 500 meters B.) 1000 meters C.) 100 meters D.) 1500 meters

Which of the following protocols are used for logical network addressing? A.) IP B.) TCP C.) ARP D.) ICMP E.) RARP F.) BootP

Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network

Which protocol will send a message to routers if a network outage or congestion occurs? A.) ARP B.) TCP C.) IP D.) ICMP

What are the 3 ways routers learn paths to destination networks? A.) Dynamic B.) Static C.) Routing tables D.) Default

Which of the following is an example of the Network Layer? A.) TCP B.) IP C.) SQL D.) Token Ring E.) LLC

Which command enables directly connected network 199.55.72.0 to be used by RIP? A. Router(config router)# rip 199.55.0.0 B. Router(config router)# rip 199.55.72.0 C. Router(config router)# network 199.55.0.0 D. Router(config router)# network 199.55.72.0

What are four functions/characteristics of the network layer of the OSI model? (Choose four) A. It uses a two-part address B. It maintains routing tables C. It uses broadcast addresses D. It establishes network addresses E. It provides access to the LAN media F. It provides media independence for upper layers G. It provides path selection for Internetwork communication

Which statement about an IP network is true? A. A broadcast source MAC address contains all zeros B. A MAC address is part of the physical layer of the OSI model C. MAC addresses are used by bridges to make forwarding decisions. IP address are used by routers. D. IP addresses allow a flat addressing scheme. MAC addresses use a hierarchical addressing scheme.

What is an advantage of local area network (LAN) segmentation? A. smaller collision domains B. elimination of broadcasts C. decreased cost of implementation D. larger number of users within the same domain

What is the result of segmenting a network with a router into segments 1 and 2? A. It increases the number of collisions B. It decreases the number of broadcast domains C. It connects segment 1 and broadcasts to segment 2 D. It connects segment 1 and broadcasts from genre to segment 2

What is NOT a characteristic of a network segment on a switch? A. The segment has its own collision domain B. The segment can translate from one media to a different media C. All devices in the segment are part of the same broadcast domain D. One device per segment can concurrently send frames to the switch.

jetking,

Your network uses a Class C address of 210.10.10.0. You must now split up the network into separate shores to handle multiple buildings separated by routers. Which two steps must you take to determine the proper shored mask for your networks? (Choose two) A. determine the number of seperate networks required B. determine how many devices will require DHCP addressing C. determine the maximum number of hosts that will be on each shored D. determine the miniumum number of hosts that will be on each shored E. determine which router will be the IP default gateway for each shored

Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction