The maximum distance on a 10BaseT network from the hub to a
workstation is
which of the following?
A.) 500 meters
B.) 1000 meters
C.) 100 meters
D.) 1500 meters
The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111
Can you explain IKE phases? Can you explain IKE modes?
IP standard access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) port C.) protocol D.) source address
Is hub intelligent device?
Which address or number is used to pass the data to the correct application? MAC Number IP address Port Number Segment Number
Choose the following that are benefits to segmenting with router: A.) Flow Control B.) Manageability C.) Multiple Active Paths D.) Explicit packet lifetime control
ok this is practical senario question how can we comunicate two diffrent network host by i single 1603 sires of cisco router rember that the cisco series of that router have singe 100mbps ethernet now think think write all command answer is so simple i wiil; give the answer after 20 visit til then wait
Which command will display Ethernet 0's IP address? A.) display ip address e0 B.) show ip interface e0 C.) show address e0 D.) sh ip address e0 E.) show all
Which of the following are solutions to the problems encountered with Distance-Vector routing? A.) Defining a Maximum B.) Poison Reverse C.) Triggered Updates D.) Shortest path first algorithm. E.) Split Horizon
Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102
The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments
what is the difference between 1 router and switch 2 router and hub 3 hub and switch 4 bridge and switch