Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer is responsible for routing through an internetwork?
A.) Physical
B.) Session
C.) Network
D.) Transport
E.) Application
F.) Data Link
- 4 Answers
- 8040 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / bala
C.Network Layer
Router works in the network layer that has the feature to
route the packet to destination.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / niraj kumar mishra
Hi All ,
Actually NIC send the packet to internetwork, means the
actual job of NIC which is Physical Address Of computer
flood the packet to internetwork.... So you guys can
understand which leyer do it..... Data link has two leyers
LLC & MAC, the MAC address is NIC Address.... so I think I
would be Data Link.
| Is This Answer Correct ? | 1 Yes | 0 No |
Which three protocols are corerectly matched to their transport layer functions? (Choose three) A. route selection IP B. sliding window UDP C. well known pods IP D. route validation ICMP E. connection oriented TCP F. three way handshake TCP G. no sequence and acknowledgement UDP
What are two characteristics of the RARP protocol? (Choose two) A. it generates parameter problem messages B. it maps IP addresses to Ethernet addresses C. it maps Ethernet addresses to IP addresses D. it is implemented directly on top of the data link layer
What is a characteristic of Store and Forward switches? A.) They work at wire speed. B.) They are the same as Cut-Through switching in 'prune' mode. C.) They forward based on transport layer info. D.) They forward the frame before it is completely read. E.) They increase latency.
Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup
You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.
Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not a the same time
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
Which protocol resolves an IP address to a MAC address? A.) DHCP B.) RARP C.) ARP D.) NBP E.) DNS
Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP
Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it
How IEEE Calculate the Cost of Link (ex.. 10mbps is having Cost 100) Is there any formula or any test to calculate it.
CCNA 
