Answer / guest

Answer: A

hi jitendra i am sunil here and i am an engineering student from delhi i have lots of interest in computer network.i was in serch of doing communication through MAC adressess.can u help me?

1 Answers  

---

Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address

4 Answers  

---

PLACE YOURS QUESTION HERE I ALSWYS BE HERE FROM 9 AM TO 6PM SO U CAN FIND YOUR ANSWER QUICKLY.IF I KNOW THEN ? JJIITTEENNDDEERRAA SSIINNHHAA

4 Answers  

---

Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register

1 Answers  

---

What is the difference between ‘bit rate’ and ‘baud rate’?

0 Answers  

---

The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'

1 Answers  

---

Which is the protocol using multiple tcp/ip connections? SLIP or PPP

2 Answers   Sutherland,

---

What is the simplest way to remotely configure a router?

0 Answers  

---

How do you find the parameters that you can use with the SHOW command? A.) ? show B.) show ? C.) debug show D.) help E.) sh?

1 Answers  

---

Explain how many maximum paths you can give on latest ios in rip?

0 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

1 Answers  

---

LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server

2 Answers  

---