Answer / rahul menon

We can use 1 RTD for temperature detection. When
temperature change, resistance also changes in RTD. This
RTD input can be given to a PLC and from the output of the
PLC a valve can be controlled based on RTD input. This
valve can inturn control the temperature of a container by
the valve ON/OFF operation.

Answer / raghavan shaji

Temperature can be controlled by providing temperature
controllers which can secnse the temperature and
communicate with the source of temperature to control it.
(ie.compressor, coolvalves,heater batteries.etc.)

Answer / pra

By maintaining two parameters-
Air(Oxygen)
Fuel

Off Load Tap changer generator Step-up Transformer, My question is, is safe to operate the tap say I want to change the tap position from 3 to 4, there is not load on the transformer but a 22000v 0r 1100 v is present on the secondary side from the common Bus *22000V/415 v

1 Answers  

---

what is difference between a NPN & PNP sensor?

0 Answers   Samtel,

---

What is the specification of transformer?

0 Answers  

---

what is load capacity of 11 cm cylinder bor 100kg. pressor?

0 Answers  

---

How to check DC Motor & SERVO Motor?

0 Answers  

---

Anyone answer what is average cost for 1 meter GI pipe Hot dipping

0 Answers   IPPL,

---

Explain about fire hydrant and its related water pressures?

0 Answers  

---

how the calculation of faut current level

0 Answers   ABB,

---

why power contactor using in DG set's neutral which is using as a stand by load during government electricity shutdown?

0 Answers   FAG,

---

how can LED bulb indication work correctly without CT OR PT for 3 phase indication if one is cut then it will show the correct indication?

0 Answers   UltraTech,

---

what is 3M

2 Answers   Samtel,

---

what is floating bearing?

0 Answers  

---