Answer / rohan

not possible

Answer / ramreborn

no way mama it should be atleast more than 1

Answer / praveen

therotically yes, but, practically no

In a constant mesh gear box, when the right dog clutch is engaged with the gear on the right side of the main shaft, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is bhp? How can you measure bhp?

0 Answers  

---

what is the role of electrical engineer in auto mobile industry,whether there is good future is there

5 Answers  

---

What is the size of the recommended compressor cfm? Where it can be used?

0 Answers  

---

Usually helicopters are having a small fan at the rear end, the purpose is;? (1) To increase it’s lifting capability (2) To balance the torque applied on the main fan (3) For safe landing (4) For safe taking off

2 Answers  

---

What do you understand by Newtonian Fluid? Where is it used?

0 Answers   Ashok Leyland,

---

Double declutching is required in constant mesh gear box a) To equalize the speed of main shaft gear and the sliding dog b) To provide direct gear c) To equalize the speed of countershaft gear and the sliding dog d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is a injecter pressure in heavy viehle?

9 Answers   Ashok Leyland, Ford,

---

Discuss the Otto cycle.

0 Answers   Ashok Leyland,

---

What are rolling bearings ?

0 Answers   Ashok Leyland,

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

prove the relation for the torque required in order to accelerate a gered system?

0 Answers   TATA,

---