A mechanism which enables the rotary motion of one shaft
to another shaft at the same axis is called
a) Gear box
b) Differential
c) Clutch
d) Flywheel
What is dtsi? Why this technology is used in motor bikes?
Why rear wheels are bigger in vehicles?
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...
In a synchromesh device, when members G1 and F1 are slid to left and cones M1 and M2 are in contact, a) Direct gear is obtained b) Second gear is obtained c) Third gear is obtained d) Reverse gear is obtained
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
The torque transmitted by a clutch is given by a) T = μWR b) T = μ/WR c) T = μW/R d) T = 1/μWR
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
Why I/P transducer is connect with 24V DC not to 220V AC?
The function of the final drive is to a) Provide a permanent speed reduction b) To turn the drive round through 90o c) To provide drive to the rear wheels d) all of the above
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam
2. What is the range of the engine efficiency for two stroke engine? Why you don’t see two stroke engine in car? What are problem with two stroke engine?
For the purpose of inflating car tyres, spray painting, etc. i.e. say a small workshop, what size of a compressor (CFM) is recommended? It will be generally for a hobby use and not commercial use.
Types of cooling system in passenger cars?