Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


Of the following, which reason applies to dividing a large
network into two or more smaller networks?
Performance
Security
Address Management

All of the above

Answers were Sorted based on User's Feedback



Of the following, which reason applies to dividing a large network into two or more smaller networ..

Answer / jitendera kumar sinha

Address Management

Is This Answer Correct ?    1 Yes 0 No

Of the following, which reason applies to dividing a large network into two or more smaller networ..

Answer / saroja hariharan

all the above

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More CCNA Interview Questions

Which protocol switch use for filling its mac-table?

0 Answers  


how to troubleshoot when protocols is down and link is not getting up

7 Answers   HCL, Sify,


In which access- list type you can't do editing?

0 Answers  


Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP

4 Answers  


Given the following IP address from the Class B address range 172.35.21.12. Your network plan requires no more than 126 hosts on a shored. Which value should you use as the subnet mask? A. 255.255.0.0 B. 255.255.128.0 C. 255.255.126.0 D. 255.255.255.128 E. 255.255.255.252

5 Answers  


What is difference between routing and routed protocols?

0 Answers  


what is difference between subnet-mask and wildcard mask?

6 Answers   IBM,


Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  


You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp

2 Answers  


Which of the following will show an extended access list 150? A.) sh access-list B.) sh ip int C.) sh ip access-list 150 D.) sh access-list 150 extended

1 Answers  


Which protocol can do load balancing on unequal cost also?

0 Answers  


Select the compression protocols for PPP? A. Stac B. Predictor C. Quality D. Magic Number

1 Answers  


Categories