What command would show the version of the IOS that you are
running?

A.) show nvram

B.) show version

C.) show startup-config

D.) show ios

E.) ver -a

F.) show ram



What command would show the version of the IOS that you are running? A.) show nvram B.) show ..

Answer / guest

Answer: B

Is This Answer Correct ?    4 Yes 0 No

Post New Answer

More CCNA Interview Questions

What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM

1 Answers  


what is stp.

4 Answers   IBM,


Write the procedure for Router for configuring DHCP?

4 Answers  


srry for inconvnce ..here is complete qs...ignore the previous 1 3 router configured with RIP & Ripv2 rotuer 1- connected with router 2 having sr ip 10.0.1.2 routing : ripv2 E0:192.168.1.10 router 2: connected with router 1 and router 3 having sr 0 ip 10.0.1.3 & sr 1 ip 11.0.1.2 routing :rip & ripv2 E0=192.168.10.2 router 3: connected with router 2 having sr ip 11.0.1.3 routing: rip E0=172.16.10.2 is there communication possible?

5 Answers   Cisco,


Explain what are the ranges of private ips?

0 Answers  


Identify the 3 guidelines for routers in the same autonomous system? A.) Must be configured for IGRP or RIP B.) Interconnected C.) Assigned the same autonomous system number D.) Configured for the same routing protocol E.) Must be same model of router

1 Answers  


Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, the router enters in its table the number 16 to signify destination unreachable

1 Answers   Google,


Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#

2 Answers  


what is stub router

11 Answers   Satyam,


Which port numbers are used by TCP and UDP to set up sessions with other hosts? A.) 1024 and above B.) 6 and 17 respectively C.) 1-25 D.) 6-17

6 Answers  


Based on the DR AND BDR discussion i want to put one question the question is what is the name of protocol which is responsible;e for DR and BDR selection

7 Answers   Patni,


What is the purpose and default value of the CDP timer command? A.) 90 seconds; interval before an entry expires B.) 60 seconds; interval between updates C.) 60 seconds; interval before an entry expires D.) 90 seconds; interval between updates

1 Answers  


Categories