Answer / jitendra roul

As per ASME hydrostatic test pressure is 1.5 times of that
of Design Pressure and pneumatic test pressure is same as
design pressure.However pneumatic is highly risky, So
always preference should be given to hydro-static test
pressure.

While conducting hydrostatic testing care should be given
to vent the air trapped during water filling at the top
most point.

Answer / peds-phil

For Hydrotesting, test pressure is equivalent to 1.5 times
the vessel design operating pressure while pneumatic is
only 1.2.

Answer / vignesh.raja63

to contect the pressure vessels depends upon the capsity of
pressure of vessle

What causes diesel engine trouble when using heavy oil?

0 Answers  

---

How many types of turbine?

8 Answers  

---

What is the difference between soldering & brazing?

3 Answers   UltraTech,

---

Dear Sir, Please send me the questions frequently asked during bhel persoal interview for supervisor trainee With worm regards, Alok Kumar Rout e-mail id- rjdalok22@gmail.com

0 Answers  

---

sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?

0 Answers  

---

---

What is mean by power factor?

1 Answers  

---

Explain the rule to find specific heat of aqueous solutions.

0 Answers  

---

What are the usual checks when induction motor is running?

0 Answers   RRB,

---

i am P.SURESH(B.Tech-Mechanical) i need previous ouestion papers of NHPC-National Hydroelectric Power Corporation Limited,please get me.

1 Answers   EIPRO, NHPC,

---

What will happen if the centrifugal pump has no pressure?

6 Answers  

---

function of waterpump

1 Answers  

---

Distinguish between creep and fatigue.

0 Answers  

---