Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 3 characteristics regarding CDP?
A.) On by default
B.) Shows only directly connected neighbors
C.) Requires IP or IPX
D.) 60 second update interval by default
E.) 30 second updates interval by default
- 1 Answers
- 5174 Views
- I also Faced
- E-Mail Answers
What are the 3 ways routers learn paths to destination networks? A.) Dynamic B.) Static C.) Routing tables D.) Default
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What is ‘round-trip time’?
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
Which of the following describe SMTP? A.) Used for downloading files to the router. B.) Used for sending e-mail. C.) Uses TCP. D.) Uses UDP. E.) Uses port 25. F.) Used for managing IP devices.
What is the difference between cross cable and straight cable?
What is size of ipv4 mac address?
How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
What is VLSM? Why we Create? When we Create? Implement VLSM with example?
Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM
Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack
Identify the command mode necessary to enter the standard ping command? A.) Router(config)# B.) Router> C.) Router(std-ping)# D.) Router(config-if)#
CCNA 
