Answer / sumit singh

10 is the width
of the tyre in
inch.20 is the
dia of rim in
inch and 16 is
the ply(layer of
thread) rating
of radial tyre

Answer / baboo kbs

10----width of the tyre
20----width of the rim
16pr--ply rating of thread

Answer / hitesh

A tyre marked 10*20-16 PR , indicates that the tyre has 10 inch section width when unloaded and it can be fitted of 20 inch diameter and the tyre has 16 ply rating,means 16 plies .

Answer / mpn

10.00 = tyre trade size in inches
20 = rim diameter in inches
16PR= ply rating of thread

Answer / raja

10= tyre width in inch
20= rim dia in inch
6pr--ply rating of thread

Answer / m.g.g

10=tyre width
20=tube sitting on rim
16=ply

Answer / anand

Then what is the diameter of the tire?

Answer / lakhan pal

10= tyre width in inch
20= rim dia in inch
P= speed rating (150 kph)
R= Radial tyre

No need to say thanx.. ur welcome anyways :)
Lakhan

resent profession and what would you define as your career objectives

0 Answers  

type ofgeneral bearing

3 Answers   RRB,

the avg piston speed of an internal combution engine increases as cylinder dimension decreases justify?

5 Answers   L&T,

relation of BSP and BSW threads in inches

1 Answers  

how to calculet the volume of torispherical head in pressure vessle design?

1 Answers   Debre Markos University,

hai this is sreenu...i also applied for the post of PO in syndicate bank..

0 Answers  

What causes cylinder liner-wear down?

0 Answers  

If mft not act when spark failure 3 time what problem will happen in boiler side

0 Answers  

How Hydrulic Power Stering & Clutch works plz explain?????????????????

2 Answers  

Why and what cause of leak fuel oil in high pressure pipe of main engine?

4 Answers  

how can I calculate daya of pump

0 Answers  

Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

0 Answers