HOW WE ARE DECIDING WHILE PROGRAMMING IN PID CONTROLLER THAT WE ARE USING HEAT

HOW WE ARE DECIDING WHILE PROGRAMMING IN PID CONTROLLER
THAT WE ARE USING HEATING OR COOLING???????

Question Posted / keval

1 Answers
3694 Views
Eskom, I also Faced
E-Mail Answers

HOW WE ARE DECIDING WHILE PROGRAMMING IN PID CONTROLLER THAT WE ARE USING HEATING OR COOLING??????..

Answer / guest

cool

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

how to measured k type thermocouple temp.

3 Answers NTPC,

What information needs for Control Valve "sizing"

1 Answers Qatar Petroleums,

What is the Flow rate ?

2 Answers

when we are using HART COMMUNICATOR why we are using 250 ohm resistance while using HART COMMUNICATOR.

7 Answers

how magentic flow tx. vortex flow tx & ultrasonic flow tx works and its prinicle?its callibtration prosedure?

1 Answers

What is surge and how is it prevented.

1 Answers ADMA OPCO,

control valve in manual/auto mode huntting checked spring tention also it is ok.positioner also good condition & incoming inst air line also constant pr.kindly give us correct answer?

5 Answers Madhu Power,

why we use 24v dc in instrument rahter than 230vac????

4 Answers

Define magnetic flow meter and mass flow meter.

1 Answers Ramco,

What is output of Thermocouple at 25 deg c

10 Answers TATA,

What is the difference between pt100, pt500 and pt1000 RTDs?

3 Answers ICI Pakistan,

which type of signal used in instrument?

3 Answers Emco, Makson, Sail, TATA,

For more Instrumentation Interview Questions Click Here