why do motors burn out? I understand why adding parallel loads to a power sou

why do motors burn out?

I understand why adding parallel loads to a power source
means more current moves through the circuit, and can
destroy circuit elements by overheating.

What about when you have a vaccuum cleaner intake flush
against a floor, a room fan sitting directly against a wall,
or a power drill trying to drill through something too hard?

Question Posted / miles.b

0 Answers
2078 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

Explain about technical and non technical losses in distribution system?

0 Answers

If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?

1 Answers Focus,

How many earthings are required for motors?

3 Answers

I have connected 04nos. earthings to a transformer through 04nos. earthing pits seperately. 02nos. earthings are connected to T/F body, and 02nos. earthings are connected to T/F neutral.T/F capacity is 2000KVA, 11KV/415V. But after completing of 02 years successful operation ,we are facing following problems- 1. CT/PT occured blast one time 2. HT cable box occured blast two times 3. One body earthing strip and one neutral earthing strip of transformer are overlapping at some places. Whenever these two strips are pressed at overlapped points, they made spark. What is the reason of spark? Please explain the reason & rectification of above problems

5 Answers

Hai, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to yuva_polisetti@yahoo.co.in

0 Answers

how the high voltages are produced?and what it causes?

4 Answers

on which power factor synchronous motor run

2 Answers Bhel,

What will happen when more than one star neutral points at same voltage level are connected to earth by metallic conductor?

1 Answers TCS,

i have 2 motor of same rating. on no load condition one motor take 1.6A but other motor is taking 4.8A. what is the reason of this. please explain with proof.

8 Answers Ambuja, UltraTech,

Find the octal equivalent for the binary number 101101110

1 Answers Ecil,

On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?

0 Answers TNEB Tamil Nadu Electricity Board,

HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.

0 Answers Areva,

For more Electrical Engineering Interview Questions Click Here