Answer / k.prakashchandra

Single stack LAs are available.The manufacturers usually
manufacture stacks ,each of 33 or 110 KV stacks and join
them in series to suit the working voltage. We have 110 KV
LA having 3 stacks of 33 KV each, also.

what is magnetizing and demagnetizing current in generator and motor?

0 Answers   HBL Power Systems,

---

what is the VA(Voltampire)? define with calculation?

4 Answers  

---

how electricity is generated through electeic generator ?

1 Answers  

---

How to calculate u.p.s load parsentage plz give me formula

1 Answers  

---

Electrical Design specifications

1 Answers   Sabic,

---

How a generator is positioned in a hydroelectric power plant?

10 Answers   Infosys,

---

is it possible to have dc motors on single chip

0 Answers  

---

Define working of prim mover governer in alternator?

1 Answers  

---

how to calculate the no. of earth pits required for an electrical installation?

1 Answers   Mepax,

---

Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers  

---

what will happen when a electric bulb is connected between two phases.it will glow or not

18 Answers  

---

I want to know what is the short circuit level when 8 NOS 2000 kVA, 415v, 50hZ generator connected in paraller

1 Answers  

---