whether a spehrical ballon rises faster or a cylindrical
ballon?
- 10 Answers
- 9011 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jitendra
Spherical ballon
Since sphere has a smallest surface area the friction
exerted on the ballon by the air will be less than that of
a cylindrical ballon which has greater surface area than
spherical ballon. Hence spherical ballon will rises faster.
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / narendra
spherical baloon because spherical shape gets less pressure
of atm. gaseous.
| Is This Answer Correct ? | 2 Yes | 0 No |
assuming both baloons to be having same volume..then both
will have same bouyantic force acting on them..now again as
u know a cylnder of same volume has more surfce area, the
weight of rubber used for a cylinderical baloon would b
higher(assuming same thicknes for both baloons), so
spherical will weigh lesser..now assuming again that the
same amount of rubber is used for both,then just drag
decides..and drag is decided by the configuration in which
the balon is rising..even a cylindircal baloon can rise
faster(assuming it to be going up length wise) if its
properly configured and left..assuming again no disturbing
forces in air..
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / karthick
in general anything in the form of spherical attains
equilibrium position faster than other form.so i guess
spherical rises faster than cylindrical
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / sharath
spherical
because of the curvy surface of spherical balloon it is easy to cut the air stream. but in the case of cylindrical balloon resistance is more due to flat face
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / dilip mishra
As we know the Pressure is inversely proportional to area ( P= F/ A) , hence spehre is less surface area which in-turn reduces the value of denominator and increase force on unit surface area then cylindrical balloon.
| Is This Answer Correct ? | 0 Yes | 0 No |
L&T construction mechanical questions
What speed you will select to drill 10 mm. In MS Plate ?
i need iocl model aptitude question papers soon as possible .so pls 4wd it to m id akakil1820022gmail.com
explain the effects of alloying chromium and nickel in stainless steel.
How to calculate center of gravity of an dynamic part having certain mass.
define hookes law?
Why pistons are usually dished at top ?
Define emissivity.
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
what is the difference between technology and engineering ?
WHAT IS DIFFERENCE BETWEEN ANNEALING,TEMPERING AND NORMALIZING
What are the protections required to protect turbine?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
