Interested to Buy Any Domain ? << Click Here >> for more details...
Which command will show you if you have a DTE or DCE
cable connected to an interface?
- 4 Answers
- 29030 Views
- DFSS, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / s.m.feroz ahmed
Hi,
DTE and DCE are defined as Data Terminal Equipment and Data
Communication Equipment.DCE is connected to Console port on
CPU for Router Configuration and DTE is used for connecting
between Systems on Network.
The Command which will show whether DTE and DCE is
connected is as below :
Router# sh Controllers or sh cont
will show information related to DTE and DCE on router.
| Is This Answer Correct ? | 6 Yes | 6 No |
Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router
Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport
what is leased line and if any issue occur what will u do thai is trouble shootin occurs let leased line is down
1 Answers Aptron, Cisco, HCL, Volvo,
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
When we use interface mode?
Which protocol can do load balancing on unequal cost also?
MIDI and MPEG are examples of what layer of the OSI seven layer model? A.) Session B.) Network C.) Datalink D.) Transport E.) Application F.) Presentation
Which defined peer ip address an local subnet belong to crete?
Which mode called privilege mode?
Identify the command that displays traffic statistics on serial0/1? A.) display interface serial0/1 B.) show interface serial0/1 C.) show seria0/1 stats D.) show interface serial0/1 stats
Which command we give if router ios stucked?
Which of the following is a layer 2 device? A.) Switch B.) Router C.) Repeater D.) Hub
CCNA 
