Interested to Buy Any Domain ? << Click Here >> for more details...
Which command will show you if you have a DTE or DCE
cable connected to an interface?
- 4 Answers
- 29026 Views
- DFSS, I also Faced
- E-Mail Answers
Answer Posted / s.m.feroz ahmed
Hi,
DTE and DCE are defined as Data Terminal Equipment and Data
Communication Equipment.DCE is connected to Console port on
CPU for Router Configuration and DTE is used for connecting
between Systems on Network.
The Command which will show whether DTE and DCE is
connected is as below :
Router# sh Controllers or sh cont
will show information related to DTE and DCE on router.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
Why we used Virtual MAC in GLBP
What is the simplest way to remotely configure a router?
What does aaa stands for?
What is cisco?
Define osi?
What is a vlan? What does vlan provide?
1350 Value in which type of access-list?
What is the subnet? Why is it used?
Which way of communication bus topology use?
Which protocol you manually enable route summarization?
What is poe (power over ethernet)?
What are the steps of data encapsulation?
How many valid ip will b in /21 in route summarization?
What is default cost of serial interface in ospf?
What requirements should a VPN fulfill?
