Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 3 characteristics of an IP address?
A.) Contains a network portion and a host portion
B.) 32 bits long
C.) Unique to each network
D.) Part of the default Cisco configuration
E.) Referred to as the hardware address
- 6 Answers
- 34251 Views
- Infosys, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A B C
An IP address is 32 bits long, it is referred as the logical
or software
address. It contains a network and host portion. Each IP
address is unique.
| Is This Answer Correct ? | 53 Yes | 8 No |
Answer / frank
A.) Contains a network portion and a host portion
C.) Unique to each network
| Is This Answer Correct ? | 28 Yes | 2 No |
Answer / anand gupta
A.Contains a network portion and host portion.
B.32 bits
c.unique to each network
| Is This Answer Correct ? | 16 Yes | 1 No |
Answer / bala chowthri
32 bit long
unique to each network
Referred to as the hardware address
| Is This Answer Correct ? | 9 Yes | 4 No |
What must be true for two routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D.) Configured for PPP
What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.
In STP the Root Bridge Sends the BPDU in Every 2 Sec,In BPDU What kind of Information is i.e. What kind of information BPDU Contains?
Identify the 3 methods routers learn paths to destinations? A.) Dynamic routing B.) None of the above, configured by default C.) Default routes D.) Administrative distance E.) Static routes
Which mode called privilege mode?
Which two statements about the store and forward switching method are true? (Choose two) A. Latency remains constant regardless of frame size. B. Latency through the switch varies with frame length. C. The switch receives the complete frame before forwarding it. D. The switch checks the destination address as soon as it receives the header and begins forwarding the fram immediately.
Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport
What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count
After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1
Explain the difference between routable and non- routable protocols?
If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through
CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office
CCNA 
