why don't we use 2 nd angle and 4 th angle projections ??????(since there

why don't we use 2 nd angle and 4 th angle
projections ??????(since there is also NOT overlapping of
VIEWS in 2 nd angle and 4 th angle projections)

Question Posted / rcm_mech

2 Answers
5918 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why don't we use 2 nd angle and 4 th angle projections ??????(since there is also NOT overla..

Answer / govind

we need only two quads to properly define a part. For
theoretical part 1st angle is gud as newbies grasp this
concept easily but manufacturing point of view 3rd is
preffered as machinist graps 3rd angle view more easily.
the reason for selecting 1st and 3rd and not 1st and 2nd or
1st and 4rth is that using diagonaly opposite quads we can
get 100% sketchable view of a part fronm every angle be it
top,front RHSV,LHSV,bottom and top. Now dont get yourself
entangled into this already messy affair and accept it as
it is because it does the job well.

Is This Answer Correct ?

6 Yes

2 No

why don't we use 2 nd angle and 4 th angle projections ??????(since there is also NOT overla..

Answer / j v

2nd angle and 4th angle are not in real only 3rd angle
projection is available.

Is This Answer Correct ?

2 Yes

10 No

Post New Answer

More Mechanical Engineering Interview Questions

hi friends kumar here if anybody of u have essar placement papers than plz send it to me i need it urgently..ok mail id is kskalyani@gmail.com

0 Answers

What is the function of a thrust bearing?

0 Answers

Suppose a steel bar of cross sectional area A is subjected to load P at one end and 2P at the other end ,what will be the induced stress in the bar?

5 Answers BARC,

Q1 WHY WE CAN NOT PUT GAS KIT IN DIESEL VEHICLE. PLEASE GIVE THE REASON IN DETAIL

1 Answers Maruti Suzuki,

function of fly wheel

15 Answers APGenco, Power Grid, RTPP,

If any machinery or transmission needs periodic and regular lubrication what is the best method to give it?

2 Answers Focus Energy, Tech Mahindra,

how we measure the through distance of grill?

0 Answers

What is the weight of 1m3 of seawater?

0 Answers

what are the alignment methods for any two turbine shafts and formulae

2 Answers

i want sample question paper for SECTION ENGINEER IN RRB.

0 Answers TVS,

If any machinery or transmission needs periodic ana regular lubrication . what is the best method to give it?

0 Answers KJH,

sir i need ongc old technical test papers can u send me immediately

1 Answers ONGC,

For more Mechanical Engineering Interview Questions Click Here