how to interface PC and 8051 microcontroller using bluetooth

Question Posted / nmsuresh

3 Answers
9741 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how to interface PC and 8051 microcontroller using bluetooth..

Answer / chandra shekhar godiwal

First arrange the circuit of 8051 with any Decoder IC. Signal decoded by this and it will receive the signal by bluetooth antenna. Mobile or PC bluetooth then using port as parallel port or mobile port it's transmit the signal after the encoding using encoder IC.

Both facility Encoder and Decoder IC --- MT8870 OR CM8870

Which is used in Cellphone Operated Robot

Is This Answer Correct ?

6 Yes

0 No

how to interface PC and 8051 microcontroller using bluetooth..

Answer / c.kumaresan

Geting some data (analogue voltage) from sensor, do simple
processing using PIC16F877A, and then send information to
my PC using Bluetooth. I've configure the UART
communication between PIC and bluetooth as shown in the
attachment.

Is This Answer Correct ?

1 Yes

0 No

how to interface PC and 8051 microcontroller using bluetooth..

Answer / ramesh

Connect the tranceiver with 8051 microcontroller.that
tranceiver used to receive and send data frm pc to
controller viceversa.

Is This Answer Correct ?

3 Yes

10 No

Post New Answer

More Electronics Communications Interview Questions

Explain why nand-nand realization is preferred over and-or realization?

0 Answers

What is the current flowing through BTS? Pls explain?

0 Answers

In india What are the best institutes for telecom job oriented training,am b.tech e.c.e fresher?

0 Answers

define why diodes are not operated in the breakdown region in rectifiers?

0 Answers

what is callibration?

1 Answers

Where lcr meter is used?

0 Answers

how snuber circuit protect the thyrister

2 Answers

how can trace the fault in any PCB? what are the steps to find problem & to troubleshoot?

0 Answers

The output of the rectifier pulsating in nature, it consists of a desired dc component of voltage and unwanted ripple components. These ripple components are removed by placing filter circuit at the output of the rectifier.

0 Answers

why we are using the bridge rectifier in most of the circuits instead of full wave rectifier even though the output of both are same?

0 Answers

Explain what are the main advantages of synchronous circuit?

0 Answers

Actually i am new to vhdl, i want to know how to declare the procedure and how to call the procedure in test bench for VHDL.... Please send answer for that...?

0 Answers

For more Electronics Communications Interview Questions Click Here