Answer / aamod tripathi

FIRST OF ALL THERE SHOULD BE A STANDARD FOR THE SUPPLY
AVAILABLE SO THAT THE MANUFACTURERS AND OTHER ALLIED
SERVICES CAN DESIGN THERE EQUIPMENTS AS PER THE STANDARD

IN INDIA (A DEVELOPING COUNTRY) IF SUPPOSE THE FIRST ERA
HAD A POWER GENERATION AT 50 HZ OF SUPPLY. SO THE NEXT
SETUPS WHICH CAME LATER ALSO CAME UP WITH 50HZ OF SUPPLY
SYSTEM SO AS TO CONTRIBUTE TO THE EXISTING SYSTEM.

why the rating of transformer in k.v.a

4 Answers  

---

In ac circuit R,L,C are connected in series what is the output the circuit? explain

4 Answers  

---

when the diameter of the core and cable is doubled, the value of capacitance ?

2 Answers  

---

A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole, 50 Hz, 3-phase slip-ring induction motor are mechanically coupled and operate on the same 3-phase, 50 Hz supply. If they are left open-circuited, then the frequency of the voltage produced across any two slip rings would be

2 Answers   L&T,

---

design a 3 bit synchronous and asynchronous counter using T- flipflop

0 Answers  

---

what is the difference b/w earthing and grounding??

2 Answers   Dodsal,

---

draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups 

0 Answers  

---

why return path in terms of neutral is required please give a relevant answer

3 Answers  

---

How to Select transformer for 100HP motor plz... With calculation

2 Answers   Rasandik,

---

all interview questions with answers of ntpc (2000-2009

0 Answers   Hetero, NTPC,

---

Why short ckt does not happen when solenoid coil connected to supply. as its a wire only.

1 Answers   Siemens,

---

what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?

0 Answers  

---