How does inter- VLAN communication take place?
A. It takes place through any Cisco router
B. It takes place through a Cisco router that can run ISL
C. It takes place through a router but this disables all the
router a security and filtering functionality for the VLANS
D. For nonroutable protocals (e.g. NetBeui) the router
provides communications between VLAN domains
E. Inter-VLAN communication is not possible because each
VLAN is a separate broadcast domain
- 3 Answers
- 17218 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / shiv
It takes place through a Cisco router that can run ISL
| Is This Answer Correct ? | 6 Yes | 1 No |
What is the name of distance vector algorithm?
How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation
What is the best Difference between RIP, OSPF, EIGRP
A default route is analogous to a _________. A. default gateway B. static route C. dynamic route D. one-way route
Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces
what is burst rate
Mention the conversion steps of data encapsulation?
When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
Which command we use for ping in ipv6?
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
i want to ask one question that why u guys are not posting the questions is any thing wrong please post question for your and others including me knowledge
CCNA 
