Interested to Buy Any Domain ? << Click Here >> for more details...
Which element is used to define the rate in bits per second
that a Frame Relay switch agrees to transfer data?
A. clock rate (CP)
B. Committed Information Rate (CIR)
C. Local Management Interface (LMI)
D. data link connection identifier (DICI)
E. Committed Rate Measurement Intercal (CRIMI)
- 2 Answers
- 8292 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / seyedfazil
Ans: a, in framerelay clock rate is defined the rate
| Is This Answer Correct ? | 0 Yes | 0 No |
Identify the command that displays ethernet0/1 interface status? A.) show interface ethernet0/1 B.) show interface ethernet e0/1 C.) show interface ethernet0.1 D.) show ethernet0/1
Which network mask should you place on a Class C network to accommodate a user requirement of ten subnetworks? A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248
What is CIDR?
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number
Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp
Which command displays the IP addresses assigned to specific host names? A. show hosts B. show interface C. ping host name D. config host name E. show host mapping F. show host ip address G. trace ip addresses host name H. a partridge in a pear tree
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
What command do you use to disable domain lookup? A.) no domain-lookup B.) domain no-lookup C.) lookup no-domain D.) no ip domain-lookup
How the STP determinw that which Port should be Root Port, which port should be Designeted Port , Blocking Port and Forwarding Port in Layer 2 STP topology........ Hi friends Thanks for posting the answer of above given questions i agree with all of you that BPDU is the Protocol that are used to determine this is clear to me.. But I want to Know the Process like Why it Blocked the port Fa0/1 Insted of Fa0/2 waiting for Answer Posting .... Thanks in Advance
When using RIP, routing updates are broadcast every ____ seconds. A. 30 B. 10 C. 60 D. 90
What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
CCNA 
