Answer / guest

Answer: C D

PPP is not the default encapsulation and uses LCP not LLC to
establish

the link. It support multiple layer 3 protocols and supports

authentication.

How can you add the 192.168.100.0/30 network to EIGRP without involving the 192.168.100.4/30 network as well?

6 Answers  

---

What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #

1 Answers   Sun Broadband,

---

How are internetworks created?

0 Answers  

---

what is stp.

4 Answers   IBM,

---

What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port

1 Answers  

---

What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC

1 Answers  

---

Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP

2 Answers   pspl,

---

Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network

2 Answers  

---

What is the simplest way to remotely configure a router?

0 Answers  

---

take a pen and copy before solving that question there is a router name Ra there is two switch sw1 and sw2 sw1 is coneceted through fa0/1 interface of router Ra sw2 is conected through the fa1/1 serai interface of router s0/1 conected through the isp with it ip address 192.168.1.1 now therer are three host conexted through the sw1 and having ip host1=10.1.2.1 host2=10.1.2.2 host3=10.1.2.3 now there is also 3ree host conected through switch 2 i.e sw2 having ip host4=10.1.1.1 host 5=10.1.1.2 host 6=10.1.1.3 now i think u have made corect confrigation.now questios is started network admin configure the Ra router in that fassion Ra(config)#access-list 2 permit 10.1.1.0 0.0.0.255 Ra(config)#line vty 0 4 ra(config)#access-class 2 in now question is that why should network admnistratoe do it in this maneer A to give access sw1 host to acess internet B to prevent sw1 host from acessing comand promt c to prevent sw2 host from accessing console of router ra D to give sw2 host access to the enternet e prevent sw1 host from accessing internet f to prevent sw1 host from acessing the sw2 host network isp------(s0/1)..RA..(fa1/1)---SW2-host (4,5,6) | | (sw1)------host 1,2,3 this is not exect digarm but help to derive the diagram plz answer as soon as possible

6 Answers   AT&T,

---

WHAT IS RIP PROTOCAL ?

3 Answers   NIC,

---

What is difference between IPv4 & IPv6??

7 Answers   Hathway,

---