Answer / v.senthilkumar

According to primary voltage variation, the RTCC gives
command to the on load tap changer which is provided in
transformer L.T side (i.e consumer side) to either increse
or decrese the L.T voltage to optain normal working voltage
to the consumer.
Tap changer should connect only in transformer consumer
side. Because the HT side line connected with main grid. So
we can not change the grid voltage.

Explain about 3 phase motor fault current calculation with examples?

0 Answers   QTC,

---

Will it be OK to connect a 5MVA 33/6.6kV Ynd11 Transformer to a Star connected Motor. Or on other words connecting a Delta to a Star. I have another 30MVA 33/11 Dyn11 and would it be practical to convert it to Dd0 consequently converting the Voltage Ratio to 33/6.35kV Dd0.

1 Answers  

---

how techometer works and how it will be connected above the flywheel in dg system

1 Answers  

---

what is inter connected dc generator?

0 Answers   Lovely Professional University,

---

hi frienda We have 750kva cater pillet dg set we are fasing one diffrent proublam in dg we are start dg set after one mint applying load around 450a load but dg was run 3 Or 4 mints after 3 mints dg was shuding down automatic how to face this proublam pls tel any budy

1 Answers  

---

---

Why the ratation of fan is anticlockwise all over the world?

2 Answers   GNFC,

---

what is different between 51N and 51G functions relay?

1 Answers  

---

why rotor winding in induction motor is not earthed. normally we uses star winding in rotor .why?

3 Answers   Anglo Platinum, TATA,

---

what is XF 200/240 V AC for Drawout Breaker.

1 Answers  

---

1 Ton is equal to how many watts?

0 Answers  

---

In electrical cables what is U and U0 refers?

11 Answers  

---

Why dont we get shock while testing for voltage with a line tester? How the bulb inside the tester glows while testing with tester coz we are totaly isolated from earth or we are not giving close path for the current to flow?

3 Answers  

---