Is electro plating what type of load whether resistive, inductive or capacitive loads

0 Answers   Apollo,

---

why insulation cost is more in underground cable than in overhead line?

2 Answers  

---

For a stable system, where should the poles of a system be in a root loci plot?

0 Answers   GE,

---

why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?

0 Answers  

---

what is meant by re-rolling motor? how it differs from standard motor?

0 Answers  

---

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

---

Which of the following can be operated at higher frequencies ? -SCR -MOSFET -IGBT

4 Answers  

---

What is meant by Energy Efficient Transformers??? give significance

1 Answers   MahaGenco,

---

In a 11KV 3phase system do you need to earth both sides of the cable?

2 Answers  

---

electical engg basic question

1 Answers   Power Plant,

---

what is the value of current and voltage that our body can resist ?

3 Answers  

---

what are the electrical components required for run the motor pump including safety components plz explain it how we can use such components .

2 Answers  

---