The transmission does not have
options:
a)Partition noise
b) Flicker noise
c) resistance
d) Short noise
and reason
we want install 11KV generator to supply power 12km far from the power house.Load to be fed is 1MW.which conductor should we use and wat will be transmission line losses?
Why does the adjacent zone of protection overlap?
What is breather? why we use it ?
What is the difference between PLC and Embeded system
how can we select the rating of Load break switch that is connected to the primary protection of 200 kva 11kv/415v distribution transformer?? step by step calculated answr pls...thnk.u
what we happen if 400 kvar cpacitor banks are on in manual mode and there is no load on mains ??????????????
how to find out this one mcb r mccb?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is HT? And specify the range of voltage?
extremely urgent please, why a fuse is used before voltmeter but not with a ammeter connected to a CT(current transformer),thanks in anticipation.
what is the use of power factor ? where its applicable ?
what is the difference b/w conductor and semicoductor