advantages and disadvamtges of using lpg in car?

Question Posted / vikram_sujan

3 Answers
16072 Views
MAHINDRA, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

advantages and disadvamtges of using lpg in car?..

Answer / balachandran

advantages

1.complete combustion
2.fuel saving
3.Homogenous combustion

disadvantages
1.as complete combustion is occuring ,more heat liberated,not advised for long journey,engine will be over heated
2.Installation is difficult

Is This Answer Correct ?

55 Yes

4 No

advantages and disadvamtges of using lpg in car?..

Answer / krunal ray

its cheap than petrol or diesel.
homogenious combusion
good option

disadv
not for long drive
no long life
reduce engine life efficiency

Is This Answer Correct ?

10 Yes

7 No

advantages and disadvamtges of using lpg in car?..

Answer / anson

LPG fueled engines can be used in long drives, the main
reason why there are engines are not able to do long drives
is because of the lack of the valve lubricant in the
system. This also goes for the reduction of the engine
life. Usually it is lack of the lubrication system. Try
to check the www.Flashlube.com this website will tell you
why you need to put this system on your car to avoid the
long term problems

Is This Answer Correct ?

2 Yes

2 No

Post New Answer

More Mechanical Engineering Interview Questions

How to identify the bearing number with 3 dimensions of bearing ID & OD & bearing outer width? In interview me answerad only the bearing ID multiply with 5. That is last two digit number.

0 Answers Al Suwaidi, Shriram Pistons, SPIPL,

What is virtual reality? & What is Walkthrough?

1 Answers

How the F.W.C. system of diesel engine circulate?

0 Answers RRB,

What are the uses of windmill?

0 Answers

Define monochromatic emissive power. [Ebλ]

0 Answers

Why fatigue strength decreases as size of a part increases beyond around 10 mm?

0 Answers

1TR IS = ? CFM

10 Answers Wipro,

where can find the information on 2R manipulator?and wat is the history of this 2r manipulator?

0 Answers

i am very much confused about direction of thrust in steam turbine...we have steam turbine of 13 stages,10 stages of impulse and 3 of reaction type....in study manual direction of thrust is towards inlet but on thrust bearing its loading side is towards condenser(exhaust side) wile also dummy ring is present in design which also restrict rotor to move in exhaust side direction not inlet ....

2 Answers

For which parts the wahl factor and lewis form factor used ?

0 Answers

Is it able to make FMEA for Pencil creation? If yes send the FMEA

0 Answers

How do i calculate compressor capacity in a refrigeration system?

5 Answers

For more Mechanical Engineering Interview Questions Click Here