In VSD (variable speed drive)I/P and O/P connections given wrongly what will h

Categories >> Engineering >> Electrical Engineering
Suggest New Category

In VSD (variable speed drive)I/P and O/P connections given
wrongly what will happen?

Question Posted / guest

5 Answers
8188 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?..

Answer / rajendran

in VFD's if the supply leads are connected in the output
side, it will damage the device permenantly....

Is This Answer Correct ?

4 Yes

1 No

In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?..

Answer / amit.sonmale

If I/P & O/P IS Conected with each other Then There will
not control on speed of motor It means Motor will directly
Conect with Suply.

Is This Answer Correct ?

3 Yes

1 No

In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?..

Answer / sony

if the i/p and o/p are wrongly connected that will lead to damage of the driver .

Is This Answer Correct ?

2 Yes

0 No

In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?..

Answer / jo

it will damage the i/o card

Is This Answer Correct ?

0 Yes

0 No

In VSD (variable speed drive)I/P and O/P connections given wrongly what will happen?..

Answer / s.magi

It will damage the IGBT and also the power board of the drive.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

how the speed of the gets motor regulated. does it draw the same current on the all speed level.

0 Answers Danko,

What are the types of power in electrical power?

0 Answers

Swg formulae

0 Answers Bokaro Steel,

Why do we need interlocking in a HT metering or Ring main unit switchgear?

0 Answers

what ll happen to current if two phases get short circuited

2 Answers Kirloskar,

How to calculate Earth busbar size & what is the procedure we make for determine that?

1 Answers

What is the most essential condition for the voltage build up for a d.c. Shunt generator?

0 Answers

If cvt is most advance & effective(economically & stability)so why not use instead of VT(11 kv & 33 kv)?

3 Answers

in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly

0 Answers Shaifali Rolls,

What is depreciation factor?

0 Answers HCC,

for measuring current and etc.,why we use value of 1.732 in three phase calculation. not in single phase.why

3 Answers Bhel,

What is SF6 Circuit Breaker?

10 Answers Sodexo,

For more Electrical Engineering Interview Questions Click Here