In VSD (variable speed drive)I/P and O/P connections given
wrongly what will happen?
- 5 Answers
- 6163 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendran
in VFD's if the supply leads are connected in the output
side, it will damage the device permenantly....
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
what is the difference between capacitive and resistive voltage divider?
what is positive , negative & zero equivalent system resistance
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
What is PQA???Applications........
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
why we use single core 630mm2 cable for transformer secondary side
How two nos. 130 kw D.C motor get synchronise using D.C drive.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
how to read idmt curva
Define sensitivity?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
