How cooling Tower height selected

Question Posted / guest

Answers were Sorted based on User's Feedback

How cooling Tower height selected..

Answer / krishna

by range and draft type

Is This Answer Correct ?

32 Yes

3 No

How cooling Tower height selected..

Answer / arshad haroon

cooling tower height depends on many factor, however design conditions like wet bulb temperature, approach and range decide the height of the tower. more the approach less is the tower height and more the range more is the tower height. however approach is more defining factor as wet bulb temperature is the theoretical lowest temp attainable by evaporative cooling(which is main mode of cooling in cooling tower in comparison to sensible cooling. still other minor factors also play role like site location wind etc.

Is This Answer Correct ?

8 Yes

0 No

How cooling Tower height selected..

Answer / kavi

depends upon contact of water

Is This Answer Correct ?

8 Yes

3 No

How cooling Tower height selected..

Answer / debasish moharana

By range and draft type

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

wat is the need to run a machine without feed???

1 Answers

How you are going to remove corruption?

17 Answers TCS,

what is mechnical engineering ?what is need of it in our life? is it essintial

1 Answers KFIL,

how to define nomenclature of bearing.

0 Answers Bhel, Cethar, TATA,

If one cylinder of a diesel engine receives more fuel than the others, then for that cylinder the: a) exhaust will be smoky b) piston rings would stick into piston grooves c) exhaust temperature will be high d) engine starts overheating e) all of the above.

7 Answers Bhel,

which network in india earning more turn over per annum

0 Answers

What are the typical indicator diagrams?

0 Answers RRB,

I want to model a piezoelectric beam in ansys software.How can I model the electrical circuit and how can I read the general current and voltage produced by the PZ?

0 Answers

Please provide me Hindustan Pretroleum Question Paper with Answers

0 Answers HAL, IOCL,

sir, Iam attending for reliance industries limited entrance exam . Please give me about the interview pattern of written and technical papers.

0 Answers

Explain in an orderly manner how the force in the member of a truss be detected using the method of joint.

0 Answers

What is the role of nitrogen in welding?

0 Answers

For more Mechanical Engineering Interview Questions Click Here