What is means turbine
Answers were Sorted based on User's Feedback
Answer / abhishek
It is the machine producing work by expanding working fluid
Is This Answer Correct ? | 5 Yes | 0 No |
Answer / rhonel
is made to revolve by a fast-moving flow of water, steam, gas, air, or other fluid.
Is This Answer Correct ? | 7 Yes | 5 No |
Answer / dinesh
it is a mechanical equipment to generator by action of water,gas,steam
Is This Answer Correct ? | 3 Yes | 1 No |
Turbine is a device which takes in steam , gas etc as an input and performs work by expanding
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / manikandan
turbine is an prime mover to drive any pump, compressors,generators etc
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / hanamant
Turbine is prime mover which converts hydel,thermal energy in to rotational energy
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / shanthi
a machine for producing continuous power in which a wheel or rotor, typically fitted with vanes, is made to revolve by a fast-moving flow of water, steam, gas, air, or other fluid.
Is This Answer Correct ? | 0 Yes | 0 No |
Why pistons are usually dished at top ?
What is a liquid flooding in refrigeration system?
What is the differance between Quality Assurance Plan & Inspection Test Plan
a cylinder, which length is 750mm and dia meter is 200mm, so find out a volume of cylinder ?
My rotary kiln die 2mtrs x 36 mtrs long bauxite calcination .PL suggest ld fan cap.and pressure.
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
WHAT ARE THE STEPS FOR SERVICING A DIESEL ENGINE? EG. 12 CYINDER ENGINE
Reason why we should avoid low speed running generator?
What is equivalence evaporation?
What is the basis of selection of type of pump (Centrifugal, Vertical Turbine)
2 Answers DAE, DCSEM, Energy Plus,
from where u will get friction factor 'f' in darcy's formula?
Machine tool guideways are usually hardening by ?