HOW TO DO GRID EARTHING IN INDUSTRIES FOR A PRODUCTION
BUILDING
Answers were Sorted based on User's Feedback
Answer / adinarayana.k
two earth pits connected in parallel(short the two earth
pits together and take two ends to connent building
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / mohamed
if earth mesh is laid during construction put earth pit in
each corner of the building.Interconnect the earth pits with
proper sized cu. ACSR conductor
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / hitesh
When Two or more Earth pits are interconnected its called a mesh or Grid. and value of earth resistance should be less than 1 ohm for a grid.
| Is This Answer Correct ? | 0 Yes | 0 No |
why induction motor's p.f 0.8
what do you mean by linear and bilateral network?
what composit error,ratio error,phase error in CT and PT??
DC transmission
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
how it can be decided what will be the rating of CT and PT to be used in LT or HT cables?
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
how can check the resistance of battery contact?
what material is the electrical housing wire made of? is there any difference for the telephone lines?
a.)Ammeter and Voltmeter read rms value or avg. value ? b.)What are symmetrical and Unsymmetrical faults?
how vector surge relay works ?
why fuse not recomended to neutral
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)