Answer / jitendera kumar sinha

farme relay is a packet switching tecnology which can
transfer the data in asynchoransah and syncronach mode of
data transfer.nad it work on data link layer

Answer / s.m.feroz ahmed

Hi,

Frame Relay is a switching without interfering any systems
and communicating with the configured system alone without
disturbing Local Systems and Network.

Answer / s.m.feroz ahmed

Hi,
Frame Relay Switching is something which can communicate
with a particular system in Network without disturbing
other systems on LAN this is the concept of Frame Relay
Switching .

what is the matric of EIGRP protocol?

0 Answers  

---

Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery

1 Answers  

---

How many voltage that passes through the ISDN?

4 Answers   CTS, Swirl Infosystems,

---

What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose four) A. Fast Ethernet uses the same Maximum Transmission Unit (MTU) B. Fast Ethernet is based on an extension to the IEEE 802.3 specification C. Fast Ethernet uses the same Media Access Control (MAC) mechanisms D. Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet E. Fast Ethernet errors a speed increase one hundred times that of the 10BaseT Ethernet

1 Answers  

---

Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, that network is advertised with an infinite metric

1 Answers  

---

1) How a router established a neighbor relation ship in ospf

1 Answers   Infosys,

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

Which of the following is an invalid host address using a netmask of 255.255.255.192? A.) 10.1.1.1 B.) 10.1.1.66 C.) 10.1.1.130 D.) 10.1.1.127

3 Answers  

---

What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase

2 Answers  

---

Which type of switching reads in the entire frame before forwarding it? A.) Tabling B.) Store-and-Forward C.) Inverse ARP D.) Fast Forward E.) Cut-Through F.) Routing

1 Answers  

---

Which types of packets used in EIGRP?

1 Answers  

---

Which of the following are examples of the Network Layer? A.) Token Ring B.) LLC C.) SQL D.) IP E.) TCP F.) IPX

3 Answers  

---