Answer / naseeb ahmeds

for that u have to first know the material which is being
conveyed by the conveyor.
Basic thing is Lump size of material:-- mm
then
1). find out the lump size factor of material
for that refer(IS 11592)
2). then find the Abrassiveness factor of the material
for that refer(IS 11592)
Add both the factor and fin out the belt conveyor speed from
IS table.this is simplest Method.otherwise it is lot of
difficult to find the speed in general.

sir I have applied for HPCL management trainee..Can i get previous MECHANICAL ENGINEERING question paper..? stalin

3 Answers   Bhel, HPCL, IOCL, RRB,

---

HOW MUCH HARDNESS OF CAST IRON?

0 Answers   TATA,

---

What is mechanism?

0 Answers  

---

When Centrifugal compressor is a non positive displacement compressor how it goes under surge due high discharge pressure when the discharge valve partially or fully clossed. please explain me clearly

2 Answers  

---

How can check gear pitch?

0 Answers  

---

what do you mean by turbine droop?

0 Answers   TATA, TNPL,

---

What are the things to do when approaching the port?

0 Answers   RRB,

---

How Does diesel generator works?

7 Answers  

---

What are the steps taken in troubleshooting of a machine e.g extruder

1 Answers   L&T, MAHINDRA, ME,

---

the specific work input during a compression cycle from p1 to p2 , if compresion is isothermal, is given by p1v1logp2/p1. explain?

1 Answers  

---

in engine when the engine stops are the pistons were stopped in between or they complete the process.

6 Answers   Honda,

---

difference between 1st angle and 3rd angle projection

0 Answers   Bhel,

---