Answer / puneet verma

1. Neighbours Definition with Co BCCH and BSIC.
2. Wrong HO Synchronisation.
3. Non Symmetrical (One Way Neighbours).
4. Adjacencies Discrepancies.
5. High TCH Congestion.
6. Missing Potential Neighbours.
7. Missing Frequencies on Active State of BA List.
8. Creation of unwanted far of Neighbours with low signal
strength
9. Abis failure (PCM related faults).
10. VSWR-DAC Values Issues.
11. BTS Hardware Issues.

Answer / herge

How can i classify the causes of those handover failures?

Answer / shekhar bhaiya

most you hang around entry level to internediate level
answers to HO failues in GSM. Here are some heavy hitters
to consider:
1. Speech Codec mismatch
2. Encryption/Ciphering mismatch

And, much more.

Cheers.

i having three wire RTD but i want analog input signal 4 to 20ma to Allen Bradly plc.so how to connect this one.pls clarifie me.

0 Answers  

---

what is amplification factor

0 Answers  

---

TELL ME 10 PRODUCTS OF TCS?

2 Answers   TCS,

---

impedence of a parallell resonant circiut at resonance:

2 Answers   Verifone,

---

Why there is no consistency in ur percentage of marks of 10th,inter and b-tech?

2 Answers   ADP, TCS,

---

I want to preparation of mppsc interview

0 Answers   MPPSC Madhya Pradesh Public Service Commission,

---

in long range commn AM is very appropriate.why?

3 Answers   Cisco,

---

what happen when unit step signal is applied to a integrater circuit.explain with graph

10 Answers   BARC,

---

what is the specialty of nand and nor gates?

0 Answers  

---

Explain what is the tri state of a signal?

0 Answers  

---

"11101111" when that bit oriented message transmitting from sender to receiver.how is it calculate parity bit and how is it show bit stream that would be transmitted..by even parity error detection scheme..pls send me an answer..very important,,

0 Answers  

---

What is the main factor for controlling the thermal generation and recombination?

0 Answers  

---