Answer / deepak vats

Boucholz relay is a device which is used for the protection
of transformer from its internal faults, it is a gas based
relay.
whenever any internal fault occurs in a transformer, the
boucholz relay at once gives a horn for some time, if the
transformer is isolated from the circuit then it stop its
sound itself other wise it trips the circuit by its own
tripping mechanism

Answer / rahul

buccholz relay is a gas-actuated(usually) relay used to
detect internal faults in a trf. It consists of two sets of
mercury floats. when faults occur inside the trf( in paper
insulation, in oil etc.) gases are produced that move the
floats to actuate an alarm ckt.
it fault not rectified quickly, ultimately it causes the
trf ckt to be tripped

The potential difference between a phase and neutral is 230v , but the potential difference between two phases is 400v. why?

4 Answers   HCL,

---

why we are using panel space heaters in different control schemes????

3 Answers   Mecon,

---

How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings

2 Answers  

---

what happens when dc supply is given to the transformer?

3 Answers  

---

what is unbalanced rotating magnetic field?

1 Answers  

---

Why Humming noise originated in Starter motor and how it was generated ?

3 Answers  

---

What is the Total Power generation Capacity in India at present ??

20 Answers   Bhel, College School Exams Tests, IBM, NTPC,

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

ups battery design formula

0 Answers   Amara Raja,

---

Where can I get Iidian straderd specifications for electrical items or works in web? please help me.

0 Answers  

---

Q2). When 3 dice are simultaneously thrown, which of the following would be obtained? (a) Result 1: “A 5, a 3 and a 6” (b) Result 2:” A 5 three times” (c) Result 3:”A 5 twice and a 3” (d) All three results are equally likely. (Musigma Question)

2 Answers   Mu Sigma,

---

What is an infinite bus bar?

34 Answers  

---