Answer / pankajkumar.s

Basically DG set is a combination of 4 Stroke Engine & Alternator.in DG set Engine is Used as Prime Mover.

A)Engine:-4 stroke Engine is Work in 4 stroke that is 1)Suction 2)Compression 3)Power 4)Exhaust.In suction stroke Air is taken From surrounding by using Air intake valve.In compression stoke with the help of piston Air is Compressed to High Velocity & High Pressure.In power stroke Fuel is injected by Drain valve.same time power is produce in power stroke.same power will pool down your piston downward.in Exhaust stroke after combustion of fuel some gases are produced same gases is exhausted with the help of exhaust valve.same piston is connected to crank shaft n crank shaft is connected to Alternator rotor .So that rotor is rotated as crank shaft rotates.

2)Alternator :Basically Alternator consist of Rotor Winding and Stator winding(also called armature).In rotor winding field is created,so Flux is cut by Stator winding.and according to faraday's law of electromagnetic induction Emf is produced in stator or armature winding.same output is coupled to your load.

Thanks & Regards,
Pankajkumar

What is the difference btwn grounding and earthing?

11 Answers   HAL,

---

A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.

0 Answers  

---

Dear all, Can anybody tell me that how to choose CT for a specific load? I have a 200kw induction motor, which ratio CT should be installed? Is there a formula or calculation that determines the CT ratio for a load? Regards.

2 Answers  

---

why we use end termination kit for ht xlpe cables

1 Answers  

---

What type of a DC motor would you use for a lift?

0 Answers   GE,

---

what is the difference between equipment earth and system earth.

1 Answers   Hofincons,

---

if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?

0 Answers   Sail,

---

why spark is produced in mosquito bat?and what are the ways to reduce it?

2 Answers   Godrej,

---

A 10 kva ,400v/200V , single phase transformer with 10% leakage impedance draws a steady short -circuit line current of

1 Answers  

---

difference between load bus and dead bus?

4 Answers  

---

can we amplify dc signals.how can it be done

4 Answers  

---

What are insulation classes? Tell examples of each of them.

1 Answers   IOCL,

---