Hy the hydro power stations have high transmission and
Distribution costs?
Answers were Sorted based on User's Feedback
Answer / guest
I dont think the distribution cost will be more than other
power sources. but yes, distribution cost will be more
usualy because these are located very far from load
centres. here the source is water at high potential and it
is not found near to populated areas.
Why distribution cost will be more, once transmitted to
load centres, the power distributin will be same
irrespective or power generated by hydro or thermal.
Any inputs on this answer are welcome.
Is This Answer Correct ? | 13 Yes | 2 No |
Answer / aves
As Plant is Located on Hilly Areas which are quite away from consumers or load centers so it requires long transmission lines, which will cost more.
Is This Answer Correct ? | 9 Yes | 0 No |
Answer / gunasekaran
transmission cost is than other power plant distribution are
same for all system
Is This Answer Correct ? | 2 Yes | 5 No |
why we use 11 kv 22 kv and so on ?
WHAT IS THE COOLANTS IN TRANSFORMER?
1. What is the exact formula for one weber? for example,(one ampere = one coulomb electron of electrons crossing a point of conductor at one second. i.e, 1A=1Q/1sec)
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
In all analog voltmeters or ammeter showing some small size symbols. as well as a star and in star 2no. digit, resister symbol,and other. what is that's meaning ?
In generating stations which we generate current or voltage if it is voltage then how it will convert to current and power?
what is neutral grounding? why is it required? what is neutral grounding resistor and how is its value calculated??
what would happen when synchronous motor will operate beyond syncronous speed?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is onbserved the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
we convert 66kv to 33kv then 33kv to 11kv,11kv to 440v.why not we convert directly from 66kv to440v?
what is meant by peak load