ENVIRONMENTAL ENGINEERING - QUESTION 22.3 : A well delivers 225 US-gallons per minute of water to a chemical plant during normal system operation. (a) Calculate its flowrate in the unit of mega US-gallon per day or MGD. (b) The following formula is written next to the chlorine feed point : (chlorine feed rate, lb / day) = (flowrate, MGD) X (dose, mg / L) x (8.34). If this formula is correct, then what should the chlorine feed rate to be in pounds per day (lb / day) if the desired dose is 2 mg / L. (c) Prove by calculations that the constant 8.34 in the formula next to the chlorine feed point is correct. Let 1 US-gallon = 3.78541 L and 1 mg = 0.0000022046 pound.

1 Answers  

---

Name some common causes of control valve noise?

0 Answers  

---

In which state sulphur exists at 40 degrees temperature and 40 atmospheric pressure in natural gas having sulphur composition 0.1 ppm?

0 Answers   Nagarjuna Fertilizers, NFCL,

---

Is it possible to compare the resistance to chloride attack of several materials of construction?

2 Answers  

---

What is an isochoric process?

0 Answers  

---

what is first order of reaction?

0 Answers   Deepak Fertilisers,

---

What is the ignition temp. of Alluminium,Coper&Iron.

0 Answers  

---

In differential centrifugation of cells with diameter D in centimeter, the square of D is given by D x D = [18n ln (RF / RI) ] / [ (RP – RFF) Wt ] where n is the fluid viscosity (poise), RF is the final radius of rotation (cm), RI is the initial radius of rotation (cm), RP is cell density (g/ml), RFF is the fluid density (g/ml), W the square for the rotational velocity in (radians / s) (radians / s), t is the time required to sediment from RI to RF (s). Derive an equation for W as a function for D, n, RF, RI, RP, RFF and t, with the stated units above, in radian

1 Answers  

---

What is pneumatic conveying?

0 Answers  

---

What are some common problems associated with dilute phase pneumatic conveying?

0 Answers  

---

ENGINEERING MECHANIC - EXAMPLE 15.2 : A cantilever beam of length L = 3 m carries a uniformly distributed load (UDL) of W = 20 N / m throughout the length. Calculate the bending moment, BM of the beam near the fixed end. What is the shear force, SF at this point? Let SF = -WL, BM = -LWL/2.

1 Answers  

---

Re: Sugar Cane Bagasse What are the 1. Specific Heat of Bagasse at 50% moisture, 40% moisture and 25% moisture? 2. What is bu;lk density of bagasse at 50% moisture, 40% moisture and 25% moisture? 3. What is specific gravity of bagasse at 50% moisture, 40% moisture and 25% moisture? 4. What is the specific heat of flue gases generated from boiler fuelled by bagasse? 5. What is the specific gravity of flue gases generated from boiler fuelled by bagasse?

0 Answers   Voice Engineers,

---