Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


How to design power source say 5KW i/p :415v 3 ph, o/p 5KW
constant, variable currnt and variable volatge 10-230v,

Answers were Sorted based on User's Feedback



How to design power source say 5KW i/p :415v 3 ph, o/p 5KW constant, variable currnt and variable ..

Answer / rajnish

by using Soft starter

Is This Answer Correct ?    3 Yes 1 No

How to design power source say 5KW i/p :415v 3 ph, o/p 5KW constant, variable currnt and variable ..

Answer / megh

in the case, you want
variable I and v. . Then
you require rectifier
and convertor ckt like
ups,drive. . . .by little
modification you can
vary both. . . . .

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

Why GRR starts from 60% of motor speed why not less than 60%?

0 Answers  


why transformer rating in KVA or MVA instead of KW n MW??

3 Answers  


Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?

0 Answers   Danieli,


what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?

0 Answers  


Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?

0 Answers  


What will happen if an AC induction motor is applied with DC voltage?????????Kindly give all the posssible answers...

2 Answers  


IT IS SAID THAT THE OLTC OPERATION SHOULD NOT BE PERFORMED WHEN THE TRANSFORMER IS GENERATION TRANSFOREMR/STEP UP MODE. WHY IS IT SO?

1 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,


Can we use 3 phase energy meter for measureing power in 2 phase 440 V phase circuit?

2 Answers  


what is relation of rpm with Power supply? rpm directly Proposational to power ?

2 Answers  


why low pressure side of the turbine is connected to the alternator and not the high pressure side??

1 Answers  


what phase and neutral.

3 Answers   HP,


mcb kitna type ka hata hai aur uska pura naam please bataye

2 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)