Answer / safi sara

since there are two input terminals in the inputside so the
resistance between the two input terminal is very very
high.so a negligible amount of current flows through op-amp
otherwise the current will be zero,then current only passes
through feedback resistance.hence the input terminal is
assumed to be virtual ground

Answer / selvam

it is like ground terminal rep by vg

Answer / vivek

opamp gain is is very high about greater than 1000
so according to formula gain A=Vo/Vi, Vo=A*Vi, Vo=1000*Vi,
so if we apply small voltage of .025V, we get o/p volatage
Vo=1000*.025=25V, so due to high gain we need very small
or negligible amount of i/p voltage or current. so we
ground the one port at i/p side it means no current flows
through it but practically it always has some value in the
fraction of ampere.

Answer / kohila

the input resistance of the amplifier is very high so the current does'nt flow through the path.so the current will flow through the feedback path

Answer / mehran ahsan

the resistance b/w the two terminals of input

Describe the working of 1φ fully controlled bridge converter in the rectifying mode and inversion mode. And derive the expressions for average output voltage and rms output voltage?

0 Answers  

Define what is meant by small signal amplifier?

0 Answers  

What are the faults that might happen in SCADA ?

0 Answers   Havells,

What is ARFCN? Which ARFCNs are allocated to Ufone?

1 Answers  

What is the state if the RED LED is glowing on DVxx card What is the state if the YELLOW LED is glowing on DVxx card What is the state if the GREEN LED is glowing on DVxx card Which frequency band DVDC is used Which frequency band DVGA is used What is the function of Bias Tee (BPxx) Which power supply card required for Ultra BTS for AC 230 V input Which power supply card required for Ultra BTS for DC -48V input Which power supply card required for Ultra BTS for DC 24V input What is the state if the GREEN LED is glowing on PWSx card What is the state if the RED LED is glowing on PWSx card What is the state if the YELLOW LED is glowing on PWSx card How many maximum PWSA cards can be inserted in a Ultra BTS cabinet How many maximum PWSB cards can be inserted in a Ultra BTS cabinet How many maximum PWSC cards can be inserted in a Ultra BTS cabinet What is the output power rating of one PWSA card What is the output power rating of one PWSB card What is the output power rating of one PWSC card What is the function of Receiver Multicoupler (M2xA or M6xA) How many TRX's are supported by one Receiver Multicoupler- M2xA How many TRX's are supported by one Receiver Multicoupler- M6xA What is the function of Remote Tune Combiner (RTxx) unit

1 Answers   Nokia,

MELF - Zener Doide is active component or passive component?

4 Answers  

please send me last year question for executive tranees in ntpc on my email ID rajthakur2091@gmail.com

0 Answers   NTPC,

What is a term "sweep" in Cathode Ray Oscilloscope?

3 Answers   CodeVita, Student, TCS,

what is CL in CL100 transistor?

1 Answers   TCS, Wipro,

Give some examples of power electronics applications in the day-to-day life?

0 Answers  

Charging & discharging of capacitor.

1 Answers  

What is a bistable multivibrator?

0 Answers