Answer / deepak

light oil is the one thr'u which we get
benzene,xylene,toluene after coal tar distillation.

Answer / tony jm

light oil

Answer / rahul naik

light oil

Question 59 – There are 5 simultaneous equations with 5 unknowns as follow : 16 V – 4 X – Z = 36, 4 X – 4 W – Y + Z = 3, 8 V + 4 W – X + Y = 10, X – W = 1, V + W = 0. Find the values of V, W, X, Y and Z accurately within 15 minutes. State the computer program that you use to get the answers.

1 Answers  

---

Mention some of the specialized crushing methods?

0 Answers  

---

Question 44 - In a non-dilute absorber, graphical method is used to represent the process. In an X - Y coordinate system, X-axis represents mole of carbon dioxide / mole of water and Y axis represents mole of carbon dioxide / mole of nitrogen. The inlet gas stream consists of 8 mol % of carbon dioxide in nitrogen. (a) Find the S / G minimum as a slope that goes through the point (0, 0.0304) and (0.0000488, 0.086957). (b) Find the actual slope of operating line when it is 1.5 times the S / G minimum! (c) Find the value of x for inlet gas stream when y = 1640 x, y is mole fraction of carbon dioxide in nitrogen.

1 Answers  

---

How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?

0 Answers  

---

The job profile as a Service Engineer?

0 Answers  

---

Question 70 - According to Adolf Eugen Fick (1829 - 1901) : rate of diffusion v increases with less wall thickness t, increased area A and decreased molecular weight of a fluid M. The diffusion constant D decreased with increasing M. (a) By assuming v, t, dP, A, M and D changes proportionally of each other, find the equation of v as a function of t, dP, A and D. (b) The ratio of self diffusion constant D, at T = 273 K and P = 0.1 MPa, for gases B and C are 1.604 : 0.155. If only 2 gases exist in such a system : hydrogen and nitrogen, find the type of gas for B and C with reference to their molecular weights M. (c) By using the equation of kinetic energy 0.5 MV = constant where V = square of v, find the ratio of V for B and V for C, or V(B) / V(C), as a function of M(B) and M(C), where M(B) is molecular weight of B and M(C) the molecular weight of C : Graham's Law of Diffusion.

1 Answers  

---

What are some typical applications for glass-lined reactors?

0 Answers  

---

I am currently doing my btech in computer science in Coimbatore.I had intererest to do btech in chemical enginerring but couldnt get a seat. Now what are my options ,scope and future if i take mtech in chemical enginerring? And can i apply for any deemed colleges for mtech chemical enginerring through gate taking my present state into consideration(btech in cse and mtech in chemical enginerring)

0 Answers  

---

What are some common precipitating agents used to remove metals from aqueous waste streams?

0 Answers  

---

What is the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?

0 Answers  

---

How can viscosity affect the design of a mixer?

0 Answers  

---

The power required for size reduction in crushing is???

5 Answers  

---