Answer / anonymous

elementary my deer friend. we do not surge arrestors because if we have too many arrestors the amount of innocent people ended up in jail will increase by 100 times. Also, transformers do not need to be fed by feeders, they can get their own food.

Sincerly, Optimus prime, roll out!

Answer / rod

We do fit surge arrestors to transformer feeders, often at
the transformer terminal box, the level of risk determins
if they are required

Answer / gunasekaran

normally transformer insulation at beginner winding more
(thicker) than motor are other equipment so surge ac cure
due to the current zero is not damaging the winding so don't
want use surge arrestor

Answer / dinesh (techie.dinesh@gmail.co

instead of surge arresters, "CONDENSER RINGS" are used.

This first turn of the HV winding is the "condenser ring".
it is connected to the HV lead( along the terminals of hv
winding).

whenever lightning or surge occurs, they are neutralized in
the condenser ring itself, without damaging the windings

Answer / yogesh

BECAUSE VOLTAGE VATIATION IS IN STEPS FOR TRANSFORMER
FEEDERS

What is principal to reduce earth leakage current with isolation transformer? When isolation transformer is installed in input stage of system, earth leakage current is reduced. the reason is why the leakage current of 2nd stage of isolation transformer does not affect the 1st stage's leakage current. I would like to know the reason. As you know, earth leakage current is a kind of AC. So, How to reduce earth leakage current in case that isolation transformer is used?

2 Answers  

What is the fundamental cause of transients in power system?

3 Answers  

WHAT IS THE MINIMUM IR VALUE FOR CABLE CHARGING

4 Answers   Google,

why pure sine wave inverter used for desktop ?

1 Answers  

Wat will happen if R-phase of an alternator is connected to B- Phase of AMF panel fed from alternator

4 Answers  

At what factor resistance r of a conductor depends?

0 Answers  

What is protection for single phasing ?

6 Answers   SISL,

design a LV scheme for a 15 storied building?

0 Answers  

how to calculate the bus bar current rating

2 Answers  

EXPLIAN THE IMPORTANCE OF POLY PHASE CIRCUIT.

0 Answers  

In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?

0 Answers  

while running ,synchronous generator is being turned off.what will happen to the current flow??

1 Answers