when giving a supply to wounded coil it will get
magnetised, but the same is not if it is not wounded on a
core..and it is getiing short....why.......

Answers were Sorted based on User's Feedback



when giving a supply to wounded coil it will get magnetised, but the same is not if it is not woun..

Answer / kk

WHEN WE GIVE SUPPLY TO A WOUNDED COIL DUE TO SELF
INDUCTANCE PROPERTY OF COIL AN EMF IS PRODUCED WHICH IS IN
OPPOSITION TO THE SUPPLY AS PER LENZS LAW

Is This Answer Correct ?    1 Yes 0 No

when giving a supply to wounded coil it will get magnetised, but the same is not if it is not woun..

Answer / srk

Dear Kk, i m also confussed from this quastion is that when
we give the supply of wounded coil it is magnetic why it is
not getting short ...?

Is This Answer Correct ?    0 Yes 0 No

when giving a supply to wounded coil it will get magnetised, but the same is not if it is not woun..

Answer / sb nair

if any winding opens giving supply to wounded coil it will
not magnetised

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

why do the alternator doesnt have open circuited windings in armature???

1 Answers  


What is knee point voltage of transformer?

0 Answers   Nabard,


HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel

0 Answers   MAB,


What will happen if mains neutral and generator neutral shorted?

2 Answers   Betts, Suzlon,


why CFL lamp requires less electricity than a normal lamp?/

3 Answers  






Please provide me detail cable voltage drop calculation

1 Answers  


can we start a 6.6kv ht motor with 415 lt supply

1 Answers  


What is the actual formula for transformer short circuit test? below i given rating of the transformer.. 1000KVA, pri 11KV, Pri amp 56A. %Z 5.95..

2 Answers  


What will happen if the field of synchronous generator is removed when it is in operation with no load?

3 Answers   HJ, UPPCL,


How do you select a cable size(cu&Al)for a particular load?

2 Answers  


what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?

0 Answers  


What is rms value wher it is used??????????

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)