who is the first atomic scientist in india?

5 Answers   IGCAR,

---

What are some common causes of control valve noise?

0 Answers  

---

MASS TRANSFER - EXAMPLE 4.3 : According to Adolf Eugen Fick (1829 - 1901) : rate of diffusion v increases with less wall thickness t, increased area A and decreased molecular weight of a fluid M. The diffusion constant D decreased with increasing M. (a) By assuming v, t, dP, A, M and D changes proportionally of each other, find the equation of v as a function of t, dP, A and D. (b) The ratio of self diffusion constant D, at T = 273 K and P = 0.1 MPa, for gases B and C are 1.604 : 0.155. If only 2 gases exist in such a system : hydrogen and nitrogen, find the type of gas for B and C with reference to their molecular weights M. (c) By using the equation of kinetic energy 0.5 MV = constant where V = square of v, find the ratio of V for B and V for C, or V(B) / V(C), as a function of M(B) and M(C), where M(B) is molecular weight of B and M(C) the molecular weight of C : Graham's Law of Diffusion.

1 Answers  

---

What is maximum recommended velocity for steam in a plant pipe network?

0 Answers  

---

NATURAL GAS ENGINEERING - QUESTION 26.3 : The United States of America Energy Information Administration reports the following emissions in million metric tons of carbon dioxide in the world for year 2012 : Natural gas : 6799, petroleum : 11695, coal : 13787. Coal-fired electric power generation emits around 2000 pounds of carbon dioxide for every megawatt hour generated, which is almost double the carbon dioxide released by a natural gas-fired electric plant per megawatt hour generated. If 1 metric ton = 1000 kg and 1 pound = 0.4536 kg, estimate the total energy generated by natural gas in the world for year 2012, in gigawatt hour.

1 Answers  

---

---

Any books are availble to read for industrial promotional officers exam.. Syllabus : PAPER-2 : Subject (Diploma Standard) Applied Science, Engineering and Management 1. MATHEMATICS 2. PHYSICS 3. CHEMISTRY 4. INDUSTRIAL MANAGEMENT 5. INDUSTRIAL ENGINEERING 6. COMPUTER APPLICATIONS & BASICS OF DOS, WINDOWS, UNIX, DB MANAGEMENT, DTP, CONCEPTS OF E-GOVERNANCE INCLUDING E-MAIL, E-COMMERCE, INTERNET, COMPUTER VIRUSES.

3 Answers   APPSC,

---

Question 73 - (a) A dryer reduces the moisture content of 100 kg of a potato product from 80 % to 10 % moisture. Find the mass of the water removed in such drying process. (b) During the drying process, the air is cooled from 80°C to 71°C in passing through the dryer. If the latent heat of vaporization corresponding to a saturation temperature of 71°C is 2331 kJ / kg for water, find the heat energy required to evaporate the water only. (c) Assume potato enters at 24°C, which is also the ambient air temperature, and leaves at the same temperature as the exit air. The specific heat of potato is 3.43 kJ / (kg °C). Find the minimum heat energy required to raise the temperature of the potatoes. (d) 250 kg of steam at 70 kPa gauge is used to heat 49,800 cubic metre of air to 80°C, and the air is cooled to 71°C in passing through the dryer. If the latent heat of steam at 70 kPa gauge is 2283 kJ / kg, find the heat energy in steam. (e) Calculate the efficiency of the dryer based heat input and output, in drying air. Use the formula (Ti - To)/(Ti - Ta) where Ti is the inlet (high) air temperature into the dryer, To is the outlet air temperature from the dryer, and Ta is the ambient air temperature.

1 Answers  

---

Explain what are the disadvantages of using gear pumps?

0 Answers  

---

sir i am senthil B.Tech Chemical Engineer which book is refer for objective type questions?

2 Answers   BARC, GATE,

---

What type of flow measurement devices is best for slurries?

0 Answers  

---

Question 34 – In the distillation of binary systems by Mc Cabe Thiele method, the equation for the line of top section is given by y = [ R / (R + 1) ] x + XD / (R + 1). 2 points on the line are (0.99, 0.99) and (0, 0.36). Find the reflux ratio of R and XD.

1 Answers  

---

How to caliculate the boil up rate, dia and height in both packed and tray distillation columns and any referance books for the design.

0 Answers  

---