Answer / kkumar

QC--- means Quality control. Ensuring the quality of the
product while manufacturing. It is before final product.
Like various measurements, surface finish, tolerence, fits
ect....

QA--- Ensuring the functionality of the component / system
after assembly

Answer / vinod kumar g

DEAR,

QC- means quality control, in which u must conntrol the
quality parameters

QA- means quality assurance, through QC u can ensure QA

Answer / sreeram_srinivas

QA = is the key process consists of senior quality
professionals, who after reviewing the Client
Specifications, applicable standards, client expectations...
define and establish procedure so that the end result would
be acceptable to client.

QC = is execution of procedures set by QA.

Note: QA monitors QC activities and its comformity to the
laid down procedures and NOT vice versa.

Answer / vaibhav dhatwalia

QA stands for quality analysis.In this there is an analyse
of quality that is it going ok or not.That means total
review of the scenario.
Ex. Suppose in a bourn vita line the if there is a leakage
of oil from a pump which is seen by some one that is
analyse.

QC stands for quality control.Which mean that how to
control the quality of the product and also the quality of
a system.this is the action taken to control or improve the
quality.
Ex. same in the bourn vita line the measures taken to
improve the quality by changing the pump or providing seal
to it is quality control.

working of nuclear power plant

0 Answers  

---

i need bhel written test question paper for the post of mechanical engineer (je)

1 Answers  

---

• Could you describe a typical day or week in this position? What are the challenges facing this position?

1 Answers   Petro Star Mount,

---

Enumerate some trouble of fuel injection valve

0 Answers  

---

What is meant by water hammering in steam line?why it is happening and how to overcome the same?

4 Answers  

---

what is Density of Fe410W IS:2062? Anyone have Density material table?

1 Answers   ABB,

---

Which Type of Stresses will be acted on Helical Springs?

4 Answers   Bhel,

---

what shows avribiations related to bearing blocks

0 Answers   Indian Steel,

---

In order to ensure constant pressure and constant flow rate of compressed air what should we put between the compressor and end user?

1 Answers  

---

What are all the possibilities discharge will be low in the pumps?

12 Answers   JSW,

---

When a 30KW/3 ph pump runs one hour continously, what will be the heat dissipated? how can i find this, any general equation?

0 Answers  

---

what's the diffrent between k engine series and qsk engine series and specialey fuel system

0 Answers   Cummins,

---