Answer Posted / sreeram_srinivas
QA = is the key process consists of senior quality
professionals, who after reviewing the Client
Specifications, applicable standards, client expectations...
define and establish procedure so that the end result would
be acceptable to client.
QC = is execution of procedures set by QA.
Note: QA monitors QC activities and its comformity to the
laid down procedures and NOT vice versa.
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
"How to check the diode, fuse and bearer switch?"
Can we integrate the C programming with Pro-e (modelling software)through application program?
Which reactor requires no moderator ?
Explain difference between modulus of resilience and modulus of rigidity ?
HOW TO calculate steam velocity on boiler o/l ?
What parameters to be reported when we send lubricating oil for shore analysis?
What is a turboprop engine?
how to calculate stiffners position and size in transformer design
"In refrigeration, why during operations is running low pressure at the suction side?"
How is technology significant in the field of mechanical engineering?
What is the difference between Runout and Total Runoutvv
Will going from a 3 tap to a 6 tap increase water pressure?
HOW CAN WE MEASURE THE L SHAPE SURFACE OF THE MOMENT OF INERTIA AND SECTION MODULUS
i have been selected for the HAL interview? what type of questions can i expect? technical or personal? pls help me in this regard and mail to sankar_aji@yahoo.co.in
calculate the expantion of steel bar 2,5 long if its temperature rises from 20 degrees to 250 degrees and its co effient of expantion is 0,000011 mm degrees